Lexmark X792 - ADF Lower Door Assembly Removal

Repair information 4-185
7562
Go Back
Previous
Next
ADF lower door assembly removal
See “ADF covers” on page 7-23 for the part number.
1. Remove the ADF front cover. See “ADF front cover removal” on page 4-170.
2. Remove the ADF platen cushion, and lay it on the scanner glass with the velcro side up. See “ADF platen
cushion removal” on page 4-193.
3. Remove the toroid from the ground wire.
4. Open the ADF lower door assembly by pressing the green tab (A).
5. Remove the screw (B) securing the ground wire.
6. Remove the two screws (C) securing the hinge plate.
7. Remove the ADF lower door assembly.
A
C
B