Diagnostic aids 3-25
7562
PRINTER SETUP
Defaults
This setting is used by the printer to determine whether US or non-US factory defaults should be selected. The
following printer settings have different US and non-US values:
Warning: Modification of the printer setting Defaults causes the NVRAM space to be restored to the printer’s
factory settings.
PAGE COUNTS
This menu lets you view the total page counts of the printer or the page counts broken down into color and mono
pages printed. Unlike in previous printers, none of these values can be changed.
Touch Back to return to the Diagnostics menu.
Serial Number
You can view the serial number.
Engine Setting x
Warning: The engine setting should not be changed without specific instructions from the next level of support.
Model Name
You can view the model name.
Configuration ID
Note: Use this only when directed by the next level of support.
The two configuration IDs are used to communicate information about certain areas of the printer that cannot be
determined using hardware sensors. The configuration IDs are originally set at the factory when the printer is
manufactured. However, you may need to reset Configuration ID 1 or Configuration ID 2 whenever you replace
the system board. The IDs consist of eight hexadecimal characters, including 0 through 9 and A through F.
Note: When the printer detects a Configuration ID that is not defined or invalid, the following occurs:
• The default standard model Configuration ID is used instead.
• Configuration ID is the only function available in DIAGNOSTICS.
• Unless the menu is in DIAGNOSTICS, Check Config ID appears.
Printer default values US value Non-US value
Paper Sizes setting in the General Settings menu U.S. Metric
Default Paper Size (paper feeding sources which do not have
hardware size sensing capabilities)
Letter A4
Default Envelope Size
(envelope feeding sources which do not have hardware size
sensing capability)
10 Envelope DL Envelope
Fax media size Letter A4
PCL Symbol Set PC-8 PC-850
PPDS Code Page 437 850
Universal Units of Measure Inches Millimeters
To Next Page
Loading...
