Lexmark X792 - Adjustments; Adjusting Skew; Finding the Source of the Skew

3-54 Service Manual
7562
Go Back
Previous
Next
Adjustments
Adjusting skew
Finding the source of the skew
Making sure the paper is square
This test is critical when cut paper is being used to align the ADF skew during reworks. Pallets of quality paper
may be found with more than 2 mm of skew.
1. Remove two consecutive pieces of paper from the ream.
2. Flip one of the pages over in the direction shown below.
3. This shows the final position of the two pages.
1
2
Long Edge
1
2
1