2-104 Service Manual
7562
200.05, 200.07—Paper Jam error service check
5
Check the cable in connector JPP2 for any
other damage.
Is the cable damaged?
Replace the paper path
cable. See “Paper path
cables” on page 7-68.
Go to step 6.
6
Remove the staging deflector assembly. See
“Staging deflector assembly removal” on
page 4-138.
Is the cable connected correctly?
Go to step 7. Reseat the cable.
7
Replace the input sensor. See “Sensor
(input, S1, narrow media, near narrow
media) removal” on page 4-137.
Does the error reoccur?
Replace the system board.
See “System board
removal” on page 4-149.
Problem solved.
Step Questions / actions Yes No
1 Reseat the ITU.
Did the error clear?
Problem solved. Go to step 2.
2
Open the left access door. Check the input
sensor flag (A) for damage.
Is the input sensor flag damaged?
Replace the input sensor
See “Sensor (input, S1,
narrow media, near
narrow media) removal”
on page 4-137.
Go to step 3.
3
Is the staging deflector assembly
damaged?
Replace the staging
deflector assembly. See
“Staging deflector
assembly removal” on
page 4-138.
Go to step 4.
4
Replace the ITU.
Did the error clear?
Problem solved. Go to step 5.
Step Questions / actions Yes No
To Next Page
Loading...
