Lexmark X792 - OP Panel Bottom Cover Removal; Printhead Access Cover Removal

4-22 Service Manual
7562
Go Back
Previous
Next
OP panel bottom cover removal
See “Front, right, and top covers” on page 7-3 for the part number.
1. Remove the operator panel assembly. See “Operator (OP) panel assembly removal” on page 4-107.
2. Remove one screw (A), and remove the speaker.
Printhead access cover removal
See “Front, right, and top covers” on page 7-3 for the part number.
1. Remove the AIO option cover. See “AIO option cover removal” on page 4-4.
Note: If you have any output options installed, then the option cover is already removed. Remove the
output options and redrive unit instead.
2. Remove three screws (A), and lift to remove the cover.
A (88A0323)
A (88A0323)