Lexmark X792 - Sensor (ADF Sheet Through) Removal; Sensor (ADF Top Door Interlock) Removal

Repair information 4-209
7562
Go Back
Previous
Next
Sensor (ADF sheet through) removal
See “ADF electronics” on page 7-27 for the part number.
1. Remove the ADF turn guide. See “ADF turn guide removal” on page 4-202.
2. Remove the screw (A) holding the sensor bracket.
3. Disconnect the sensor cable.
4. Remove the screw to remove the sensor from the bracket.
Sensor (ADF top door interlock) removal
See “ADF electronics” on page 7-27 for the part number.
1. Remove the ADF feed drive motor assembly. See “ADF feed drive motor assembly removal” on
page 4-180.
2. Disconnect the cable from the sensor.
3. Remove the screw (A) if you need to replace the bracket.
4. Press in the tabs under the sensor bracket (B) to remove the sensor.
A
AB