Lexmark X792 - MPF Wear Strips Removal; Operator (OP) Panel Assembly Removal

Repair information 4-107
7562
Go Back
Previous
Next
MPF wear strips removal
See “Left and rear covers” on page 7-5 for the part numbers.
1. Open the left access door assembly.
2. Insert a flat-blade screwdriver behind the top of the strip, and then twist the screwdriver to pop out the strip.
Operator (OP) panel assembly removal
1. Remove the scanner top cover. See “Scanner top cover removal” on page 4-216.
2. Remove the AIO front upper cover. See “AIO front upper cover removal” on page 4-3.
3. Remove the AIO front lower cover. See “AIO front lower cover removal” on page 4-3.
4. Remove the scanner left side front cover. See “Scanner left side front cover removal” on page 4-214.
5. Remove three screws (A) from the top.
A (88A0323)