7-72 Service Manual
7562
3002501 Flange M3.0 x 6 mm Scanner interface card to flatbed 4
88A0011 Machine M2 x 0.4–
6G 3LG
Operator panel display bracket to display 6
88A0212 Taptite Metal
M3.5 x 6 mm PAN
AIO flat cable bracket to frame 3
AIO left support frame to frame 8
AIO LS rear bracket to frame 3
AIO rear support frame to frame 4
AIO right support frame to frame 4
AIO RS rear bracket to frame 3
Datum guide/thermister assembly to frame 4
Cartridge contact block assembly to front frame 3
Cartridge memory block assemblies to rear frame, 2 per assembly 8
Cartridge rail assemblies to frame, left and right, 1 per rail 8
EP drive assembly to frame 8
Exit cooling fan duct assembly to frame 1
Flatbed scanner assembly to frame 5
Fuser drive assembly to frame 3
Ground cables to frame 4
LVPS to frame 3
Media tray rails to bottom plate, 1 per rail 2
Operator panel assembly to frame 1
Post to HVPS board and frame plate above it 2
Rear cover to system board cage and frame 2
Rear upper cover to rear cover 2
Redrive motor to frame 2
Rear cover to rear frame 3
Rear upper cover to rear cover and frame 3
Right cover to lower front frame 1
System board cage to support 1
System board cage to upper frame 2
Top cover to top frame 3
Waste toner left cover 5
Screw identification table (continued)
P/N Screw type Location Qty
To Next Page
Loading...
