4-144 Service Manual
7562
• Place the slot in the ITU DS roller plate over the ridge on the frame, and then swing the plate into place to
reattach the two screws.
• Check the alignment of the reference edge. See “Staging paper path reference edge adjustment” on
page 4-145.
Notes:
• When installing the staging paper path reference edge, do not turn the adjustment screw
during installation.
• Do not replace, or adjust the printhead and the staging paper path reference at the same time.
• See “Pick arm stuck down service check” on page 2-191 to put the pick arm back to its
original position.
To Next Page
Loading...
