Driving
5.3 Driving the truck crane and switching it off
Operating manual 3 302 709 en 5 - 43
GMK5150L
12.01.2018
Additional brakes Engine retarder
The truck crane has an engine flap brake which it uses as an engine retarder.
The engine retarder only becomes effective at an engine speed of 950
rpm
and can be used up to a maximum speed of 2,300
rpm.
Transmission retarder
The truck crane can also be rigged with a transmission retarder. The braking
force of the transmission retarder depends on the speed. The higher the
speed, the higher the braking power.
H
For long downhill stretches, we recommend that you use level 2. When the
transmission retarder is switched on, you cannot regulate the speed with
the accelerator.
Switching on the additional brakes
• Pull the switch back to the required level
(latch into place briefly at each level).
Switching off the additional brakes
• Press the switch upwards to level 0.
When the additional brake is switched on, the lamp (1) lights up.
G
Risk of accidents from unexpected acceleration
Maintain sufficient distance when the engine retarder is switched on.
The effectiveness of the engine retarder is interrupted during gear shifting.
This may cause the truck crane to accelerate briefly.
1 20% brake power
2 40% brake power
3 60% brake power
4 80% brake power
5 100% brake power
To Next Page
Loading...
Need help?
General
