Crane operation
11.6 Settings and displays for crane operation
Operating manual 3 302 709 en 11 - 129
GMK5150L
12.01.2018
11.6.7 Setting the characteristic curves for the control levers
The control lever characteristic curve determines how high the power unit
speed should be for a particular control lever movement.
You can assign different control lever characteristic curves to the power
units.
• Open the Settings (1) menu.
The symbols (2) show the set characteristic
curves of the power units (1).
• Select the power unit for which you would
like to change the characteristic curve.
• Set the desired characteristic curve.
Select and confirm symbol (3) to reset all
power units to characteristic curve 1.
There are five characteristic curves:
The higher the number of the characteristic
curve (1) to (5), the further the control lever
must be moved to get a clear increase in
speed.
With characteristic curve (5), you can work
particularly sensitively with the control lever.
To Next Page
Loading...
