Driving modes and rigging for on-road driving
6.6 Installing/removing the outrigger beams
6 - 52 3 302 709 en Operating manual
GMK5150L
12.01.2018
6.6.1 CHECKLIST: Removing the outrigger beams
H
This checklist is not a complete operating manual. There are accompanying
operating instructions which are indicated by cross-references.
Observe the warnings and safety instructions specified here!
1. Preparing the truck crane;
à p. 6 - 57.
2. Label the outrigger beams, retract, release and bolt them to each other;
à p. 6 - 56.
3. If necessary, remove the outrigger pads;
à p. 6 - 58.
4. Unscrew the spacer;
à p. 6 - 62.
5. – Disconnecting hydraulic connections;
à p. 6 - 60.
– Disconnect the electrical connection if necessary;
à p. 6 - 61.
To Next Page
Loading...
