Starting the engine for driving / switching it off
4.1 Starting the engine from the driver's cab
Operating manual 3 302 709 en 4 - 17
GMK5150L
12.01.2018
4.1.10 Setting the idling speed
After the engine is started, the idling speed is regulated automatically.
If necessary, you can adjust the idling speed manually.
H
You can only set the idling speed when the truck crane is stationary.
Increasing/reducing the idling speed
• Press the button (1) repeatedly until Engine
speed
is shown in the on-board computer
display.
• Increase or decrease the speed stepwise
using the buttons (2) or (3). The engine
speed is increased/reduced by 20 rpm.
After about 3 seconds the setting is
automatically saved.
Switching off the idling speed change
• Press the button (1) repeatedly until Engine
speed
is shown in the on-board computer
display.
• Press the button (3).
or
• Press the button (2).
or
• Accelerate to more than 20 km/h (12 mph).
To Next Page
Loading...
