Basic safety instructions
2.6 Instructions on transporting persons
2 - 12 3 302 709 en Operating manual
GMK5150L
12.01.2018
The person being transported must be in radio contact with the crane
operator.
When used for transporting persons, the truck crane must not be used for
other tasks.
The crane operator is not permitted to exceed the maximum permissible
wind speeds and wind loads for transporting persons applicable in the
country in which he is working. These values are normally lower than
those for lifting loads specified in the
lifting capacity table.
When the equipment for lifting persons is being used and is in a stationary
position, then the slewing gear, hoist, derricking gear and telescoping
mechanism must be secured against accidental use by being switched off.
Truck crane The truck crane must be equipped (e.g. with hydraulic emergency opera-
tion) so that the equipment for lifting persons can be set down and the
persons being transported can safely leave it even if there is a failure of
the drive or crane controls.
The hook holding the lifting gear for the equipment for lifting persons must
be fitted with a lockable latch that completely seals the hook opening.
The truck crane must be serviced as prescribed, regularly inspected and
repaired, if required. All safety stickers must be affixed in their appropriate
places and be legible.
To Next Page
Loading...
Need help?
General
