Page 38
Alterations reserved Stand 12/02
Operating Manual T 700 / T 800 - FP ENG
4.2 Lubrication / Cleaning
>NOTICE< Generally, the machine should be cleaned after each job, particularly moveable
parts which have been changed due to change of sheet size, because heavy dust may cause
reduction of function.
4.2.1 Feeder
Check the loose ends 1 of the pile
plate chains, clean it off from dust and
provide it with a slight touch of oil.
Move the pile table up in its top
position for these works !
4.2.2 Vaculift
Remove protective hood 1 and
put a slight touch of spray-oil
onto all guiding elements
and moving parts, monthly.
> NOTICE < If you add too much
spray-oil lubricant may drop onto
the sheets through the knife guide.
To Next Page
Loading...
