Seite 78
Alterations reserved
Stand 05/2008
Operating manual T700/T800.1 - en
5.7.9 Guard above the slitter shaft
See para. 5.6.10
5.7.10 Miscellaneous
For certain kind of folds at which the quantity of buckle plates of folding unit I are not enough, you
may also place the folding units in line behind eachother.
> NOTICE < In folding unit I you should process folds as less as possible in this configuration, but
as much as possible in folding unit II.
> NOTICE < The speeds of all folding units should correspond with eachother. Normally, a gap of
1-2 cm on the cross carriers is sufficient.
To Next Page
Loading...
