MBO T700 - Double sheet control adjustment; Double sheet control procedure

Seite 54
Alterations reserved
Stand 05/2008
Operating manual T700/T800.1 - en
5.4.3 Double sheet control
Press the lever 1 and insert a paper strip (which you are running) into the gap 2 between the bolt 3
and the knurled screw 4.
Insert a double paper strip under the segment 5. Turn the knurled screw 4 until the segment 5 has
switched and tighten the knurled nut 6 after the adjustment of the double sheet control has been
completed.
If you check with a single paper strip the machine must continue to run. Re-adjust, if
necessary!
Please note that the double sheet control stops the sheet infeed at first. The machine will
stop if no sheets are in the machine!