Page 81Alterations reserved Stand 12/2002
Operating Manual
T 700 / T 800 - R ENG
5.6.7 Guard above the slitter shaft
See para. 5.5.10
5.7.10 Miscellaneous
For certain kind of folds at which the quantity of buckle plates of folding unit I are not enough, you
may also place the folding units in line behind eachother.
>NOTICE< In folding unit I you should process folds as less as possible in this configuration, but as
much as possible in folding unit II.
>NOTICE< The speeds of all folding units should correspond with eachother. Normally, a gap of
1-2 cm on the cross carriers is sufficient.
To Next Page
Loading...
