Seite 79Alterations reserved Stand 05/2008
Operating manual T700/T800.1 - en
5.7.11 Double Stream Device (Optional)
To process from 2 x 8 thru 2 x 32 pp.
Double stream devices installed in buckle folding machines provide more productivity. Use only
when you process large quantities due to extensive set-up time. Make arrangements for
corresponding imposition layouts betwen printer and finisher!
Normally, the sheets run into the 1st folding unit with their wide side. They are cut on the
slitter shafts after the parallel fold. The double-stream device is to be installed onto the subsequent
folding units. Both parts of the sheet run parallel side by side into the next individual folding
unit.
This device consists of a short sidelay 1, one conveyor table 2 and two additional sheet stops 3 for
the buckle plates.
Continuation
To Next Page
Loading...
