Page 84
Alterations reserved Stand 12/2002
Operating Manual T 700 / T 800.1 - FP ENG
5.6.9 Double Stream Device (Optional)
To process from 2 x 8 thru 2 x 32 pp.
Double stream devices installed in buckle folding machines provide more productivity. Use only
when you process large quantities due to extensive set-up time. Make arrangements for
corresponding imposition layouts betwen printer and finisher!
Normally, the sheets run into the 1st folding unit with their wide side. They are cut on the slitter
shafts after the parallel fold. The double-stream device is to be installed onto the subsequent folding
units. Both parts of the sheet run parallel side by side into the next individual folding unit.
This device consists of a short sidelay 1, one conveyor table 2 and two additional sheet stops 3 for
the buckle plates.
Continuation
To Next Page
Loading...
