Page 62
Alterations reserved Stand 12/2002
Operating Manual T 700 / T 800.1 - FP ENG
5.5.3 Sheet deflectors
Buckle plates which are not used
should be pulled out and the
deflector be shifted 1.
Replace the buckle plates and tighten
them with the clamping levers.
Heavy or multiple folded sheets
may require an increase of the
folding space 2, for this purpose
remove the deflector a little bit.
If you pull out the deflector at one side
only it may influence the perforating 3,
scoring or cutting line which deviates
from the desired direction 4.
To Next Page
Loading...
