Seite 59Alterations reserved Stand 05/2008
Operating manual T700/T800.1 - en
5.6.2 Buckle plates
Insert the buckle plates 1
into the lateral support rails 2.
The buckle plate (or deflector)
will bump with their stop screw 3 against
the stop bolt 4 in its deepest (basic)
position. Lock buckle plates on both
sides with clamping lever 5.
> NOTICE < Make sure that the buckle
plates are pushed against
the foldrollers 4 and rest on it.
Setting of folding length: Loosen metal
knurled screw 6 and adjust with
adjustment ring 7. The necessary size
can be read-off at toothed belt with
mm-indicator 8 and red indicator 9.
Change of stop angle
10:
When folding out-of-square
sheetsloosen plastic knurled screw 11
and turn the frontal adjustment ring 12.
The O-position is shown by two marks
on the adjustment rings.
Twits screw 13 for fine adjustments.
How to change the lower plate lip 14 :
Turn hexagon nuts 15 simultaneously
at both sides: Basic adjustment =
consider 0-markings 16.
Heavy papers:
remove the lower plate lip 14
off the foldrollers.
Thin papers:
move the lower plate lip 14
to the foldrollers.
Continuation
To Next Page
Loading...
