MBO T700 - Protective Hoods - Checklist of Parallel Unit;Feeder and Mobile Folding Units; Safety Devices - Machine

Page 15Alterations reserved Stand 12/2002
Operating Manual
T 700 / T 800 - R ENG
2.3 Safety devices - machine
2.3.1 Protective hoods - Checklist of parallel unit/feeder and mobile folding units
Pos Identification Function
control
Visible
control
Result Note
1
Two-pieced protective
hood over parallel
unit
2
Protective hood over
slitter shafts
Locked electron. if hood is
open ”V“ = 70 mtrs/
Mte. (tipping mode)
3
Guard over foldrollers
4
Guard over parallel
unit
at drive and operator
side
5
Cover handwheel at drive and operator
side
6
Guard over drive of
suction tape or
suction wheel
at drive side
7
Guard over drive of
suction tape or
suction wheel
8
Guard over drive of
suction tape or
suction wheel
9
Protective angle
before suction tape or
suction wheel
See page of Operating
Manual for Setting
Instructions
10
Guards over
handwheel
11
Guard plate below
parallel unit
at exit of folding unit
12
Guards above drive
belt cross carrier
At drive side
13
Guards before drive
belt Cross carrier
At drive side
14
Guard point of draft
tape roller
Upper table
15
Guard over drive
chain
At drive side, internal
16
Cover, external
chain tensioner
Upper table
17
Guard over drive
chain
At drive side, internal
18
Guard over drive
chain
At drive side, internal
19
Guard
p
late from drive
to operator side
20
Guard over drive shaft
of gear
At drive side, internal
21
Cover, external
drive shaft
On drive side, external
Date Name Signature