Page 71Alterations reserved Stand 12/2002
Operating Manual
T 700 / T 800 - R ENG
5.6.13 Pre-slitter shafts (option) - Applications
Tear-off perforations:
Tear-off perforations (very small teeth)
are carried out more precisely
with pre-slitter shafts, i.e. only
one product thickness is perforated.
>NOTICE< Set the guide roller 1 and
the first foldroller 3 according to the
thickness of the product being feeded.
Please bear in mind that the pre-slitter
shaft 2 must always be set to
double-thickness of product.
Interrupted perforations:
Remove upper slitter shafts 2
and place plastic counter rollers 5
onto the lower slitter shafts 4.
Affix perforating heads 6 and
place them above pos. 5.
Use sufficient smoothers 8.
Please follow the enclosed
individual Operating Manuals
for operating and connecting
the individual perforating heads.
Remoistable glue:
Remove the upper 2 and lower 4
slitter shafts. The lower slitter shaft 4
is replaced by a another shaft
delivered with.
Gluing devices of different
manufacturers can be affixed onto the
cross bar 7 which has to be installed.
Please follow the enclosed
individual Operating Manuals
for operating and connecting
the individual gluing devices.
To Next Page
Loading...
