Seite 66
Alterations reserved
Stand 05/2008
Operating manual T700/T800.1 - en
5.6.8 Scoring
> NOTICE < Basically, crossfolds with buckle plates should be pre-scored if you do not
perforate! Without scoring it is not ensured that the fold will always be exactly in the desired
position.
The scoring knife 1 must be placed
between two transport rollers 2
(or counter knives) at the round side.
When running pulp board sheets you
should score on the rubber part
of the transport roller 3.
For this purpose use a scoring knife
with a smaller outer diametre!
Special scoring devices may
also be used upon request.
5.6.9 Cutting
For separation of multiple-up
production you should use
one (or multiple) knives 1.
The installation occurs in the
same way as perforating knife.
To Next Page
Loading...
