Page 83Alterations reserved Stand 12/02
Operating Manual
T 700 / T 800 - FP ENG
5.6.7 Guard above the slitter shaft
See para. 5.5.11
5.6.8 Miscellaneous
For certain kind of folds at which the quantity of buckle plates of folding unit I are not enough, you
may also place the folding units in line behind eachother.
> NOTICE < In folding unit I you should process folds as less as possible in this configuration, but
as much as possible in folding unit II.
> NOTICE < The speeds of all folding units should correspond with eachother. Normally, a gap of
1-2 cm on the cross carriers is sufficient.
To Next Page
Loading...
