Page 24
Alterations reserved Stand 12/2002
Operating Manual T 700 / T 800.1 - R ENG
3.2.7 Guards
>DANGER< Use and affix
all protective hoods which
have been delivered with!
Fasten the noise hood 1
under the register table
with four screws 2.
Hook-in the door 3 with the tool drawer.
Insert the buckle plates, place the guide rails on, place the slitters onto the slitter shafts,
tension the transport tapes etc. All these works are described under the following paragraph
„Operation of the Machine“.
To Next Page
Loading...
