Page 4
Alterations reserved Stand 12/02
Operating Manual T 700 / T 800 - FP ENG
5.3 Register table ....................................................................................................... 54
5.3.1 Vacu-Alignment (standard) ............................................................................................................ 54
5.3.2 Double sheet control...................................................................................................................... 55
5.4 Sheet infeed control ............................................................................................. 56
5.4.1 Automatic learning of suction length and sheet gap .................................................................. 56
5.4.2 Photocells (Standard) .................................................................................................................... 57
5.4.3 Photocells in folding units II and III (option) ................................................................................ 58
5.5 Parallel folding unit .............................................................................................. 59
5.5.1 Setting of foldrollers and slitter shafts ......................................................................................... 59
5.5.2 Buckle plates .................................................................................................................................. 60
5.5.3 Sheet deflectors ............................................................................................................................. 62
5.5.4 Combination buckle plate KFT (optional)..................................................................................... 63
5.5.5 Slitter shafts (Standard) ................................................................................................................. 64
5.5.6 Photocell at exit of folding unit ..................................................................................................... 64
5.5.7 Perforating ...................................................................................................................................... 65
5.5.8 V-shaped special perforating knife (optional) ..............................................................................67
5.5.9 Scoring ............................................................................................................................................ 68
5.5.10 Cutting............................................................................................................................................. 68
5.5.11 Guard above rear perforator shaft (Standard)..............................................................................69
5.5.12 Guard above pre-slitter shafts (option) ........................................................................................ 70
5.5.13 Pre-perforator shaft and rear twin-perforator shafts (option) ..................................................... 71
- setting of foldrollers and slitter shafts ....................................................................................... 71
5.5.14 Pre-slitter shafts (option) - Applications ...................................................................................... 73
5.5.15 Twin-rear slitter shafts (Option) - Applications............................................................................ 74
5.6 Mobile buckle folding units ................................................................................. 75
5.6.1 Installation ...................................................................................................................................... 75
5.6.2 Electrical connection ..................................................................................................................... 76
5.6.3 Control panel .................................................................................................................................. 77
5.6.4 Set-up mode of buckle folding machines .....................................................................................78
5.6.5 Sheet transportation ...................................................................................................................... 79
5.6.6 Exit of folding unit .......................................................................................................................... 82
5.6.7 Guard above the slitter shaft ......................................................................................................... 83
5.6.8 Miscellaneous ................................................................................................................................. 83
5.6.9 Double Stream Device (Optional).................................................................................................. 84
5.6.10 Two-up production at one sidelay ................................................................................................. 86
5.7 Noise damping device (option) ........................................................................... 87
6.0 Instructions to the user ....................................................................................... 88
To Next Page
Loading...
