Name: Mitsubishi GOT1000 Series
Brand: Mitsubishi
Rating: 4 (1 reviews)

To Next Page

To Previous Page

8 - 22

8.3 PLC Side Setting

8.3.1 Connecting to Ethernet module (Q Series)

(2) Operational settings

: Necessary : As necessary : Not necessary

*1 Because port No. 5001 is fixed, these items operate at the following setting without relations to the setting given

here.

• Communication date code : "Binary code"

• Initial timing : "Always wait for OPEN" (Communication is applicable while stopping the

PLC CPU.)

• Enable Write at RUN time : "Enable Write at RUN time" (Writing Data is applicable while running the

PLC CPU.)

When changing the network parameter

After writing the network parameter to the PLC CPU, operate the PLC CPU ether

turning OFF and then ON or resetting.

(3) Communication confirmation

The INIT. LED on the Ethernet module turn on when the module is ready to communicate.

For confirming the communication state, refer to the following.

Confirming the communication state of Ethernet module

*2 The LEDs layout of QJ71E71-100.

Item Setting

Setting necessity at GOT

connection

Communication date code

(Use default value.)

IP address 192.168.0.19

Initial timing

(Use default value.)

Send frame setting

Enable Write at RUN time

TCP Existence confirmation setting

QJ71E71-100

RUN

INIT.

OPEN

ERR.

COM.ERR.

100M

Questions and Answers:

Need help?

Do you have a question about the Mitsubishi GOT1000 Series and is the answer not in the manual?

Mitsubishi GOT1000 Series Specifications

General