7 - 8
7.3 BootOS and System Application Installation Using Data Storage
(2) When installing with USB memory
Step 1.
Install the USB memory where the BootOS, system application or project data is stored in the USB
interface of the GOT.
Step 2. Display the data control function screen (Utility) on the GOT, and install basic system application from the
USB drive to GOT.
Step 3. The USB memory access LED is lit during install execution.
Do not pull out the USB memory or power OFF the GOT while the USB memory access LED is lit.
Step 4. The GOT restarts automatically after the installation is completed.
Step 5. After confirming normal restart, confirm that the USB memory access LED is not lit.
Display the USB device status screen and remove the USB memory from the USB interface of GOT.
âž 4.2.3 USB device status display operation
To Next Page
Loading...
Need help?
General
