11.1 Standard I/F
11 - 9
COMMUNICATION INTERFACE SETTING (COMMUNICATION SETTING)
11
■2. For Standard I/F-4(Ethernet)
POINT
POINT
Communication parameter setting by drawing software
Set the communication parameter for each communication driver by selecting [Common] →
[Controller Setting].
➠ GT Designer3 (GOT2000) Help
Step 1. Touch the driver display box of a
communication parameter to be set.
Step 2. The screen is switched to the
communication detail setting. Set the
communication parameter on this
screen.
GOT IP address setting
➠ 11.2 GOT IP Address Setting
Step 3. When the button is touched, it
returns to the previous screen.
Step 4. Touch the button to display the
window confirming whether to save the
settings.
Step 5. Touch the [YES] button to save the
settings and restart. Touch the [NO]
button to discard the changes.
To Next Page
Loading...
