been set.
Start
Touch [Restore] on the main menu.
Input the password for the backup/restoration.
Automatic authentication is conducted using
the password on the controller side saved in
the backup data.
Input the changed
password on the
controller side manually.
File is restored.
Restoration is completed.
No
Yes (for other than FXCPU)
No
No
No
No
Yes
Yes
Yes
Yes
Is the password correct?
Is the password correct?
Is there any other file?
Is there any password set
for the file to be restored?
Is there any other units?
(When a multiple CPU system is used)
If a keyword has been set, clear it.
When the PLC is not in the STOP status,
change its status to the STOP status.
Yes (for FXCPU)
Is there any other controller
that is to be backed up?
(When a controller list file exists)
No
Yes
To Next Page
Loading...
