16.3 FX3U-ENET-ADP Communication Setting Function
16 - 43
GOT SELF CHECK (DEBUG)
16
Step 5. When the screen shown on the left
appears, the changed communication
set value of the FX3U-ENET-ADP is
written normally to the CPU. For making
valid the contents of setting, turn OFF
the power of the CPU, and then turn it
ON again. Change the setting of the
subnet mask pattern and default router
IP address using the same procedure if
necessary. An error message appears
in the following cases. Touch the
key to return to the step , and
perform the setting procedure again.
• When the CPU is running
The following error message appears.
Stop the running status of the CPU.
• When a communication error occurs
Set the communication between the
GOT and the CPU to the normal
status.
• When the memory cassette is write-
protected
Set to OFF the write-protect switch of
the memory cassette.
• When writing to the CPU is protected
by the keyword
Clear the protection by the keyword
against writing.
To Next Page
Loading...
Need help?
General
