Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 2-79 P/N 196515 (Revision A)
Lesson 2-9
Dispensing Calibration Module
A. Introduction
The Dispensing Calibration Module consists of the Weigh Station, Purge Station,
Needle Sensor, Tactile Sensor and Ceramic Tile. The stainless steel housing
protects the components from fluid spills and work area mishaps. Occasionally,
the Dispensing Calibration Module may need to be leveled.
B. Enabling Objective
2.9 Identify Dispensing Calibration Module components and perform
procedure to level the Dispensing Calibration Module.
C. Topic Outline
1. Introduction
2. Overview
Dispensing Calibration Module Components
Dispensing Calibration Module Leveling and Height Adjustment
3. Summary and Review
To Next Page
Loading...
