Nordson Asymtek X-1000 Series User Manual

Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 5-45 P/N 196515 (Revision A)
Lesson 5-8
Removing and Replacing the XY Servo Interface PWA
A. Introduction
The XY Servo Interface PWA is located on the Servo Shelf and contains all signal
routing going to the dispensing head except for the camera coax cable and the
CAN communication. The following lesson outlines the procedure to remove and
install the XY Servo Interface PWA.
B. Enabling Objective
5.8 Perform the procedure to remove and install the XY Servo Interface PWA.
C. Topic Outline
1. Introduction
2. Overview
 Removing the XY Servo Interface PWA
 Installing the XY Servo Interface PWA
3. Summary and Review

Nordson Asymtek X-1000 Series Specifications

General

Brand	Nordson
Model	Asymtek X-1000 Series
Category	Dispenser
Language	English