Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 5-9 P/N 196515 (Revision A)
Lesson 5-3
Removing and Replacing Pneumatic Solenoid Valves
A. Introduction
The Pneumatic Valve Manifold controls airflow to pneumatic components in the
Conveyor area such as the Stop Pins, Lift Tables/Clamp Bars, and Vacuum
Generators. This manifold can consist of up to eight Pneumatic Solenoid Valves
(PSVs) depending on your system’s configuration.
B. Enabling Objective
5.3 Perform the procedure to remove and replace Solenoid Valve modules.
C. Topic Outline
1. Introduction
2. Overview
 Removing a Solenoid Valve
 Replacing a Solenoid Valve
3. Summary and Review
To Next Page
Loading...
Need help?
General