Training Guide Course No. 196514
Level 2 Maintenance, X-1000 Series Dispensing Systems 2-25 P/N 196515 (Revision A)
Lesson 2-4
Pneumatic Distribution
A. Introduction
The X-1000 Dispensing Systems uses compressed air at up to 120 psi of pressure
for the conveyor stop pins and board clamp, the vacuum generator, the dispense
valve, the syringe cooler and the needle heater.
B. Enabling Objective
2.4 Understand the X-1000 series pneumatic system and distribution.
C. Topic Outline
1. Introduction
2. Overview
Main Air Regulator and Gauge
Main Air Solenoid
Fluid Pressure Regulator and Gauge
Valve Pressure Regulator and Gauge
Tooling Air Pressure Regulator and Gauge
Dual Action Solenoid
Low Pressure Sensor
Stop Pin Valve
Clamp/Lifter Valve
3. Summary and Review
To Next Page
Loading...
