Polaris 2015 RZR 900 - Page 246

6.8
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
12.Remove the prop shaft 15 from the transmission
output shaft (see Chapter 7 – Prop Shaft Removal,
page 7.20 ).
13.Remove rear wheels from the vehicle.
14.If internal transmission repair is required, drain the
transmission lubricant (see Chapter 2 –
Transmission Lubrication, page 2.19).
15.Remove the stabilizer bar mounting bolt and nut
15
from both sides. Discard nuts and replace with new
upon assembly.
16.Remove the fasteners
16
attaching the upper control
arms to the bearing carriers (left and right side).
Discard nuts and replace with new upon assembly.
Allow the radius rods swing downward.
17.Pivot the control arms downward and maneuver the
drive shafts out of the vehicle frame.
CAUTION
Be careful not to stretch the brake line when pivoting
the bearing carrier downward.
TRANSMISSION