System Commands
Polycom, Inc. 166
● camera near setposition 100 100 219
returns
camera near setposition 100 100 219
● camera near getposition
returns
camera near getposition 100 99 218
● camerainvert near get
returns
camerainvert near off
● camerainvert near on
returns
camerainvert near on
● camerainvert near off
returns
camerainvert near off
Limitations
camera near 2 is not supported on RealPresence Group 300 and 310 systems.
camera near 3 is not supported on RealPresence Group 300, 310, and 500 systems.
camera near 4 is not supported on RealPresence Group 300, 310, and 500 systems.
camera for people 2 is not supported on RealPresence Group 300 and 310 systems.
camera for people 3 is not supported on RealPresence Group 300, 310, and 500 systems.
camera for people 4 is not supported on RealPresence Group 300, 310, and 500 systems.
camera for content 1 is not supported on RealPresence Group 300 and 310 systems.
camera for content 2 is not supported on RealPresence Group 300 and 310 systems.
camera for content 3 and 4 are not supported on RealPresence Group 300, 310, and 500 systems.
Comments
The camera commands function only when the system is in a wake state. If necessary, use the wake
command prior to using the camera commands.
If the camera near {1..4} API command is used for an input configured as content, the command
becomes a toggle. You must send the command once to send the content source and a second time to stop
the content source.
As of release 4.1.1, the camera register and camera unregister commands are no longer available.
Use the notify vidsourcechanges command instead.
After using a camera command to move a Polycom EagleEye Producer or Polycom EagleEye Director
camera, you must use the
camera <near|far> stop
command to update the camera position.
To Next Page
Loading...
Need help?
General
