R&S SMB100A User Manual

Instrument Function
R&S
®
SMB100A
90Operating Manual 1407.0806.32 ─ 21
●
RF Level Sweep
see Chapter 5.3.7.3, "RF Level Sweep", on page 182
●
ALC
see Chapter 5.3.5.4, "Automatic Level Control - ALC", on page 151
●
Power Sensors
see Chapter 5.3.6.1, "NRP-Z Power Viewer", on page 166
●
User Correction
see Chapter 5.3.5.6, "User Correction", on page 158
The analog and external digital modulations are activated in the "Modulation" function
block:
●
Amplitude Modulation
see Chapter 5.4.2, "Amplitude Modulation (AM)", on page 198
●
Frequency Modulation
see Chapter 5.4.3, "Frequency Modulation (FM)", on page 202
●
Phase Modulation
see Chapter 5.4.4, "Phase Modulation (PhiM)", on page 206
●
Pulse Modulation
see Chapter 5.4.5, "Pulse Modulation (PM)", on page 209
●
Stereo Modulation
see Chapter 5.4.6, "Stereo Modulation", on page 211
The internal LF generators, the LF frequency sweep and the pulse generator are con-
figured in the "Mod Gen" function block:
●
LF Frequency Sweep
see Chapter 5.5.3, "LF Frequency Sweep", on page 220
●
LF output
see Chapter 5.5.2, "LF Output", on page 218
5.2 General Instrument Settings
5.2.1 Overview of General Instrument Settings
This section describes the settings which do not directly affect signal generation. Most
of these settings can only be accessed by means of menus which are opened using
keys or key combinations on the external keyboard or keys on the front panel key emu-
lation.
The general instrument settings therefore affect various functions, such as storing
instrument settings using the FILE key or setting the GPIB address in the menu of the
SETUP key. The order in which the descriptions are given corresponds to the layout of
the keys on the front panel of the R&S SMB (from top left to bottom right).
General Instrument Settings

R&S SMB100A Specifications

General

Brand	R&S
Model	SMB100A
Category	Inverter
Language	English