To Next Page

To Previous Page

Remote Control Commands

R&S

SMB100A

348Operating Manual 1407.0806.32 ─ 21

Parameters:

<Impedance> HIGH | G600

HIGH

> 100 k0hm to ground

*RST: HIGH

Example:

INP:MOD:IMP HIGH

sets > 100 kOhm to ground.

Manual operation: See "Ext. Impedance" on page 201

[:SOURce<hw>]:INPut:MODext:WIGNore

Ignores warnings concerning an overload of the modulation signal input.

This setting is not affected by an instrument preset *rst or the and Save/Recall func-

tion. Only the factory preset resets this setting.

Parameters:

<SuppressState> 0 | 1 | OFF | ON

*RST: 0

Example:

INP:MOD:WIGN ON

suppresses the overvoltage warnings.

Manual operation: See "Ignore Overvoltage Warning" on page 202

[:SOURce]:INPut:TRIGger:SLOPe <Slope>

Sets the polarity of the active slope of an externally applied trigger signal at the trigger

input (BNC connector at the rear of the instrument).

The setting is effective for both inputs at the same time.

Parameters:

<Slope> NEGative | POSitive

*RST: POSitive

Example:

INP:TRIG:SLOP NEG

Activates the falling slope of the external trigger signal at the

trigger input.

Manual operation: See "Ext. Trigger Input Slope" on page 182

7.13.6 SOURce:LFOutput Subsystem

The SOURce:LFOutput subsystem contains the commands for setting the LF signal

source in CW and Sweep mode and for analog modulation.

SOURce Subsystem

R&S SMB100A User Manual

Other manuals for R&S SMB100A