R&S SMB100A User Manual

Remote Control Commands
R&S
®
SMB100A
290Operating Manual 1407.0806.32 ─ 21
Example:
DIAG:INFO:OTIM
queries the operation hours.
Response: 100023
The instrument was operated for 100023 hours up to now.
Usage: Query only
Manual operation: See "Operation Time / h" on page 94
:DIAGnostic:INFO:POCount?
The command queries the number of power-on events.
Return values:
<Pocount> float
Example:
DIAG:INFO:POC
queries the number of power on events.
Response: 123
The instrument was switched on for 123 times up to now.
Usage: Query only
Manual operation: See "Power On Count" on page 95
7.6 DISPlay Subsystem
The DISPlay subsystem contains the commands to set the power-save mode of the
instrument.
:DISPlay:ANNotation:AMPLitude..................................................................................... 290
:DISPlay:ANNotation:FREQuency....................................................................................291
:DISPlay:ANNotation[:ALL]..............................................................................................291
:DISPlay:DIALog:CLOSe................................................................................................ 291
:DISPlay:DIALog:CLOSe:ALL..........................................................................................291
:DISPlay:DIALog:ID?...................................................................................................... 291
:DISPlay:DIALog:OPEN..................................................................................................292
:DISPlay:PSAVe:HOLDoff...............................................................................................292
:DISPlay:PSAVe[:STATe]................................................................................................292
:DISPlay:UPDate........................................................................................................... 293
:DISPlay:ANNotation:AMPLitude <State>
Indicates asterisks instead of the level values in the status bar.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example:
DISP:ANN:AMPL ON
Suppresses the level display.
DISPlay Subsystem

R&S SMB100A Specifications

General

Brand	R&S
Model	SMB100A
Category	Inverter
Language	English