R&S SMB100A - Status:questionable:ntransition; Status:questionable:ptransition; Status:queue[:Next]

Remote Control Commands
R&S
®
SMB100A
432Operating Manual 1407.0806.32 ─ 21
Parameters:
<Event> string
Example:
STAT:QUES:EVEN?
queries the Status:Questionable:Event register.
:STATus:QUEStionable:NTRansition <Ntransition>
Sets the bits of the NTRansition part of the STATus:QUEStionable register. If a bit is
set, a transition from 1 to 0 in the condition part causes an entry to be made in the
EVENt part of the register.
Parameters:
<Ntransition> string
Example:
STAT:OPER:NTR 0
a transition from 1 to 0 in the condition part of the Status:Ques-
tionable register does not cause an entry to be made in the
EVENt part
:STATus:QUEStionable:PTRansition <PTransition>
Sets the bits of the NTRansition part of the STATus:QUEStionable register. If a bit is
set, a transition from 1 to 0 in the condition part causes an entry to be made in the
EVENt part of the register.
Parameters:
<PTransition> string
Example:
:STAT:OPER:PTR 32767
all transitions from 0 to 1 in the condition part of the Sta-
tus:Questionable register cause an entry to be made in the
EVENt part
:STATus:QUEue[:NEXT]?
Queries the oldest entry in the error queue and then deletes it. Positive error numbers
denote device-specific errors, and negative error numbers denote error messages
defined by SCPI. If the error queue is empty, 0 ("No error") is returned.
The command is identical to :SYSTem:ERRor[:NEXT]? on page 435.
Return values:
<Next> string
Example:
:STATus:QUEue?
queries the oldest entry in the error queue.
Response: 0, 'no error'
no errors have occurred since the error queue was last read out
Usage: Query only
Manual operation: See "History" on page 70
STATus Subsystem