To Next Page

To Previous Page

Instrument Function

R&S

SMB100A

104Operating Manual 1407.0806.32 ─ 21

Remote command:

:SYSTem:TIME on page 446

Time Zone

Selects the time zone.

You can select the time zone according to the major cities on the respective conti-

nents.

Note: By typing the first letter, you can quickly navigate through the lists to find the

desired destination.

Remote command:

:SYSTem:TIME:ZONE on page 446

:SYSTem:TIME:ZONE:CATalog? on page 446

5.2.3.12 Network Settings

The "Network Settings" dialog shows the parameters relevant for identifying the instru-

ment in a network. The R&S SMB is equipped with a network interface and can be

connected to an Ethernet LAN (local area network).

How to connect the signal generator to the network is described in Chapter 2.6.1,

"Connecting the Instrument to the Network", on page 35.

Risk of network errors!

Connection errors can affect the entire network.

If your network does not support DHCP, or if you choose to disable dynamic TCP/IP

configuration, you must assign valid address information before connecting the instru-

ment to the LAN.

Contact your network administrator to obtain a valid IP address.

► To access this dialog, press the SETUP or MENU key and select "Environment >

Network Settings".

General Instrument Settings

R&S SMB100A User Manual

Other manuals for R&S SMB100A