R&S SMB100A User Manual

Status Information, Error Messages and Troubleshooting
R&S
®
SMB100A
487Operating Manual 1407.0806.32 ─ 21
Error
Code
Error Description Remedy
460 Cannot open file The selected file can not be opened. Check the path and file name.
461 Cannot write file The file can not be written. Check if the file is read-only.
462 Cannot read file The file can not be read. Check if the file contents are
compatible with the file type.
463 Filename missing The required operation cannot be
executed because the file name is not
specified.
A file name has to be entered
when creating a new list.
464 Invalid filename exten-
sion
The file extension is not valid for the
required operation.
Check the file extension.
For instance, the file extension
for waveform list files is *.wv. It
is not possible to enter another
file extension when storing a list.
465 File contains invalid
data
The selected file contains data that is
not valid for the file type.
The file extension determines the
data that is valid for this file type. If
the file extension is changed the lists
are no longer recognized and the data
are therefore invalid.
Example: the extension of a wave-
form file (= *.wv) was changed to
*.txt
Check the file extension.
Stereocoder error messages
An error occurred concerning the stereo coder option R&S SMB-B5. Refer to the ser-
vice manual, chapter 3, section "Troubleshooting" for error correction.
9.5 Resolving Network Connection Failures
Several issues may cause failures in the network connection to the instrument. This
section lists the most likely reasons and the recommended solutions.
Common reasons for network connection failures
●
Network connecting cables and cable connectors of poor quality
●
Incompatibility between the network interface of the R&S SMB and certain
switches or routers available on the market
●
An invalid IP address assigned to the instrument
Resolving Network Connection Failures

R&S SMB100A Specifications

General

Brand	R&S
Model	SMB100A
Category	Inverter
Language	English