To Next Page

To Previous Page

Remote Control Commands

R&S

SMB100A

288Operating Manual 1407.0806.32 ─ 21

Example:

CAL:LEV:EXT:DATA FACT

selects the use of the data aquired at the factory for external

level correction.

Manual operation: See "Adjustment Data" on page 151

:CALibration<hw>:ROSCillator[:DATA] <Data>

Sets the calibration value for the custom defined external adjustment.

Parameters:

<Data> integer

Range: 0 to INT_MAX

*RST: 0

[:SOURce]:CALibration:STEReo:ANALog[:MEAS]?

The command starts all adjustments which affect the analog channels of the stereo

coder option.

Return values:

<Meas> 0 | 1

Example:

CAL:STER:ANAL?

starts the adjustments for analog channels of the stereo coder.

Response: 0

the adjustments have been performed successfully.

Usage: Query only

Options: R&S SMB-B5

Manual operation: See "Adjust Stereo Coder" on page 94

7.5 DIAGnostic Subsystem

The DIAGnostic system contains the commands used for instrument diagnosis and

servicing. SCPI does not define any DIAGnostic commands; the commands listed here

are all device-specific. All DIAGnostic commands are query commands which are

not influenced by *RST.

:DIAGnostic<hw>:BGINfo?..............................................................................................288

:DIAGnostic<hw>:BGINfo:CATalog?................................................................................ 289

:DIAGnostic:INFO:OTIMe?..............................................................................................289

:DIAGnostic:INFO:POCount?.......................................................................................... 290

:DIAGnostic<hw>:BGINfo? [<Board>]

Checks the modules available in the instrument using the variant and revision state.

DIAGnostic Subsystem

R&S SMB100A User Manual

Other manuals for R&S SMB100A