R&S SMB100A - Source:stereo Subsystem

Remote Control Commands
R&S
®
SMB100A
408Operating Manual 1407.0806.32 ─ 21
Example:
ROSC:SOUR EXT
Selects the external source.
ROSC:EXT:FREQ 5 MHz
Informs the instrument that the external reference has a fre-
quency of 5 MHz.
Manual operation: See "Source" on page 143
7.13.15 SOURce:STEReo Subsystem
This subsystem contains the SCPI commands for generating FM stereo multiplex sig-
nals, the radio traffic service ARI (Automotive Radio Information) and Radio Data Sys-
tem (RDS). Additional functions are available using the SOURce:STEReo:DIRect
commands (see Chapter 7.19, "Direct Commands for the Stereo/RDS Coder Option
R&S SMB-B5", on page 456).
[:SOURce]:STEReo:ARI:BK[:CODE]................................................................................ 408
[:SOURce]:STEReo:ARI:STATe...................................................................................... 409
[:SOURce]:STEReo:ARI:TYPE........................................................................................409
[:SOURce]:STEReo:ARI:TYPE:STATe............................................................................. 410
[:SOURce]:STEReo:ARI[:DEViation]................................................................................ 410
[:SOURce]:STEReo:AUDio:MODE...................................................................................410
[:SOURce]:STEReo:AUDio:PREemphasis........................................................................411
[:SOURce]:STEReo:AUDio:PREemphasis:STATe............................................................. 412
[:SOURce]:STEReo:AUDio[:FREQuency]......................................................................... 412
[:SOURce]:STEReo:DIRect.............................................................................................412
[:SOURce]:STEReo:EXTernal:IMPedance........................................................................413
[:SOURce]:STEReo:MMF............................................................................................... 413
[:SOURce]:STEReo:PILot:PHASe....................................................................................413
[:SOURce]:STEReo:PILot:STATe.................................................................................... 414
[:SOURce]:STEReo:PILot[:DEViation].............................................................................. 414
[:SOURce]:STEReo:RDS:DATaset.................................................................................. 414
[:SOURce]:STEReo:RDS:STATe.....................................................................................414
[:SOURce]:STEReo:RDS:TRAFfic:ANNouncement[:STATe]...............................................415
[:SOURce]:STEReo:RDS:TRAFfic:PROGram[:STATe]...................................................... 415
[:SOURce]:STEReo:RDS[:DEViation]...............................................................................415
[:SOURce]:STEReo:SOURce..........................................................................................416
[:SOURce]:STEReo:STATe.............................................................................................416
[:SOURce]:STEReo[:DEViation].......................................................................................417
[:SOURce]:STEReo:ARI:BK[:CODE] <Code>
Selects the area identification (BK) code of the ARI signal. The six letters (six different
frequencies) identify a specific region in each country. The code is generated if the BK
or DK+BK identifier of the ARI signal is activated.
Parameters:
<Code> A | B | C | D | E | F
*RST: A
SOURce Subsystem