R&S SMB100A - Page 430

Remote Control Commands
R&S
®
SMB100A
415Operating Manual 1407.0806.32 ─ 21
Parameters:
<State> 0 | 1 | OFF | ON
*RST: OFF
Example:
STER:RDS:STAT ON
activates generation of RDS signal.
Options: R&S SMB-B5
Manual operation: See "RDS State - Stereo Modulation" on page 216
[:SOURce]:STEReo:RDS:TRAFfic:ANNouncement[:STATe]
<State>
Activates the RDS traffic announcement. If activated, the receiver switches from the
current status, e.g. playing a CD, to the receive mode and enables the broadcast of a
traffic announcement. The TP state has to be on.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: OFF
Example:
STER:RDS:TRAF:PROG:STAT ON
activates RDS traffic program.
STER:RDS:TRAF:ANN:STAT ON
activates RDS traffic announcement.
Options: R&S SMB-B5
Manual operation: See "RDS Traffic Announcement State - Stereo Modulation"
on page 218
[:SOURce]:STEReo:RDS:TRAFfic:PROGram[:STATe] <State>
Activates the RDS traffic program. The receiver can recognize a frequency as being
capable of traffic information only if the TP function is active.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: OFF
Example:
STER:RDS:TRAF:PROG:STAT ON
activates the RDS traffic program.
Options: R&S SMB-B5
Manual operation: See "RDS Traffic Program State - Stereo Modulation "
on page 217
[:SOURce]:STEReo:RDS[:DEViation] <Deviation>
Sets the deviation of the RDS subcarrier.
SOURce Subsystem