R&S SMB100A - Sense

Remote Control Commands
R&S
®
SMB100A
316Operating Manual 1407.0806.32 ─ 21
:SENSe<ch>[:POWer]:FILTer:SONCe..............................................................................320
:SENSe<ch>[:POWer]:FILTer:TYPE................................................................................ 320
:SENSe<ch>[:POWer]:LOGGing:STATe...........................................................................321
:SENSe<ch>[:POWer]:FREQuency..................................................................................321
:SENSe<ch>[:POWer]:OFFSet........................................................................................322
:SENSe<ch>[:POWer]:OFFSet:STATe............................................................................. 322
SENSe<ch>[:POWer]:SNUMber?.................................................................................... 322
:SENSe<ch>[:POWer]:SOURce.......................................................................................323
SENSe<ch>[:POWer]:STATus[:DEVice]?......................................................................... 323
SENSe<ch>[:POWer]:SVERsion?....................................................................................323
SENSe<ch>[:POWer]:TYPE?..........................................................................................324
:SENSe<ch>[:POWer]:ZERO.......................................................................................... 324
:SENSe<ch>:UNIT[:POWer]............................................................................................324
:SENSe<ch>[:POWer]:APERture:DEFault:STATe <UseDefAp>
Deactivates the default aperture time of the respective sensor.
To specify a user-defined value, use the command :SENSe<ch>[:POWer]:
APERture:TIMe on page 316.
Parameters:
<UseDefAp> 0 | 1 | OFF | ON
*RST: 1
Example:
SENS:POW:APER:DEF:STAT 0
deactivates the default aperture time of the sensor.
Manual operation: See "Use Default Aperture Time" on page 173
:SENSe<ch>[:POWer]:APERture:TIMe <ApTime>
Defines the aperture time (size of the acquisition interval) for the corresponding sensor.
Parameters:
<ApTime> float
Range: depends on connected power sensor
Increment: 1E-9
*RST: depends on connected power sensor
Example:
SENS:POW:APER:TIM 23ms
sets 23 ms aperture time.
Manual operation: See "Aperture Time" on page 173
:INITiate<ch>[:POWer]:CONTinuous <Continuous>
The command switches the local state of the continuous power measurement by the
R&S NRP-Zxx power sensors on and off. Switching the local state off enhances the
measurement performance during remote control
SENSe, READ and INITiate Subsystems