R&S SMB100A - Page 485

Remote Control Commands
R&S
®
SMB100A
470Operating Manual 1407.0806.32 ─ 21
Setting parameters:
<Phase> Note: A two-digit value must always be set with a sign ("+" or
"-") in front of it. Leading zeros, if any, must also be specified.
Range: -5.0 to +5.0 (ASCII coded decimal numbers), cor-
responding to ±5.0
Example:
STEReo:DIRect "PIL-PH=-33"
The pilot tone phase is set to 3.3
Example:
STEReo:DIRect? "PIL-PH"
Response: "-33"
STEReo:DIRect "PRE=<Preemphasis>"
STEReo:DIRect? "PRE"
(for documentation reasons only)
Sets one of various preemphasis options.
Use the SCPI commands [:SOURce]:STEReo:AUDio:PREemphasis:STATe and
[:SOURce]:STEReo:AUDio:PREemphasis instead.
Setting parameters:
<Preemphasis> 0 | 1 | 2
0
Off
1
50 us
2
75 us
Example:
STEReo:DIRect "PRE=1"
The preemphasis is set to 50 us.
Example:
STEReo:DIRect? "PRE"
Response: "1"
STEReo:DIRect "PRESET"
Sets the default settings in accordance with specifications.
Example:
STEReo:DIRect "PRESET"
Usage: Event
STEReo:DIRect "PS=<PS>"
STEReo:DIRect? "PS"
Sets or reads the RDS program service (PS) name.
Direct Commands for the Stereo/RDS Coder Option R&S SMB-B5